ABB | SACE Tmax XT
30 | © 2019 ABB | 1SDH002039A1002 - ECN000093027 - Rev. A Interface and menus | 4 - Menu
4 - Menu
Introduction
Press Enter or ESC from the main page to access the different menus of the Trip unit.
The menus are the 4th level pages that can be dislpayed and comprise list of:
• submenus
• settable parameters
• information and measurements
• commands that can be executed
Selection of each menu item enables: access to submenus, consultation of information in detail, configuration
of a parameter, execution of a command.
Elements of each item
The items in each list consist of:
• main name (white color)
• additional description or set value (light blue color)
Figure 21
Protections Menu
The Protections menu can be used to configure the following protections
(1)
:
Name Parameters SW package Page
L List and description in dedicated chapter
Standard
Protections
40
S List and description in dedicated chapter 41
S2 List and description in dedicated chapter 42
I List and description in dedicated chapter 43
G
(2)
List and description in dedicated chapter 44
(1)
if the Adaptive Protections package is available and Dual set has been activated, an intermediate menu
where the set can be selected (Set A / Set B) will be available before the list of protections page 67).
(2)
available for LSIG versions
To Next Page
Loading...
