To Next Page
A
Alex HamptonAug 12, 2025
How to fix red lights on ABB jokab safety Smile Tina Control Unit?
- JJohn PachecoAug 12, 2025
If the ABB Control Unit shows red lights, it could be due to the E-stop button being down. To resolve this, reset the button by turning it clockwise and pulling it upward. Another cause could be the absence of a 24 VDC input to pin-2 (no dynamic signal). In this case, check if there is 24 VDC to input (pin- 2). If yes, inspect the cable or the unit before it, and fix any issues.
General
