PCS100 ESS User Manual | 2UCD190000E001 rev. J 3
Overview of this Manual
About this Manual
This manual contains information regarding:
– the general functions of the PCS100 ESS
– the user interface, control and possible adjustments of the PCS100 ESS
– installation and commissioning of the PCS100 ESS
Usage
This manual should be used during operation and adjustment of the PCS100 ESS. It should be referenced when:
– integrating the PCS100 ESS into a complete BESS system
– operating and adjusting the PCS100 ESS
– commissioning the PCS100 ESS
Who should read this manual?
This manual is intended for:
– integrators of the PCS100 ESS
– installation personnel
– operators
Prerequisites
An installation/repair/operator person working with the PCS100 ESS must:
– be trained by ABB and have electrical operational and safety knowledge
– have sufficient training to operate in an accidentally touch safe service environment
Software Revision
This User Manual applies to PCS100 ESS systems with software revision R2M2.
Note: To locate the current software release number, on the GDM’s Control Panel, press Product.
The release number is labeled “Release: …”.
To Next Page
Loading...
