4 Transporting, unpacking and storage
4.1 Transporting
CAUTION!
Surge arresters not secured during transportation
Damage to surge arresters that have fallen during transport.
X
Secure the surge arresters against sliding or falling before transportation.
X
Observe the safety precautions printed on the packaging for proper handling during
transportation and storage.
X
Don’t expose the disconnectors or surge arresters equipped with disconnecting devices
to temperatures above +60 °C (for exceptions, see specific product documentation).
4.2 Unpacking
The surge arresters provided are packaged in sturdy cardboard boxes or wooden crates.
If accessories are included in the order, the surge arresters are supplied with accessories
installed. If specifically requested, accessories are packaged separately in plastic bags and
are either included in the cardboard box or wooden crate or supplied separately in case of
large quantities.
The routine test reports for the final electrical inspection are included in the packaging
material.
X
After receiving the shipment, compare the order and delivery documents immediately to
check for completeness and correctness of the shipment.
X
In case of incompleteness or deviations, inform the supplier and shipper immediately.
Packaging material is one-way unless stated otherwise. It shall be disposed of or recycled
according to local regulations.
WARNING!
Damaged surge arresters
Material damage and personal injury due to the installation and commissioning of damaged
surge arresters.
X
Do not use damaged surge arresters.
X
Examine shipment immediately to check for damage.
X
Immediately notify the insurance company, the shipper and the supplier of the damage
and create a damage log.
4.3 Storage
The original packaging materials can be used for storage.
X
Store the surge arresters in a well-ventilated, clean room.
X
Remove the plastic film to prevent the formation of condensation water.
Storage temperature: –40 ... 70 °C
Storage temperature for disconnectors or surge arresters equipped with disconnecting
devices: –40 ... 60 °C (for exceptions, see specific product documentation).
1HC0141361 AA | EN | Operating instructions | 7
To Next Page
Loading...
Need help?
General
