15
3.6.5 Alarm indicators
The audio alarm has a series of beeps based
on the active mode or a particular warning.
See Table 8 below for the number/duration
of beeps for warning/mode.
—
Table 8: Alarm function list
No. Status Alarm
1 Battery mode
Beeps once every
2
Battery mode with
battery low
Beeps once every second.
3 Bypass mode
Beeps once every
4 Overload
Beeps twice every
second.
5
Warning active
(See Warning &
Fault Code Table)
Beeps once every second.
6 Fault active Beeps continuously.
7 Button function active Beeps once.
3.6.1 Battery mode
To mute the audio alarm in battery mode, press
the ON button continuously for 1 second. The
audio alarm is active again when the battery
reaches low status as a reminder that the UPS
output power will shut down soon.
3.6.2 Bypass mode
To mute the audio alarm in bypass mode, press the
OFF button continuously for more than 1 second.
This does not affect the warning and fault alarm.
3.6.3 CVCF mode
The UPS can be used in CVCF mode without
batteries. This will cause the Open Battery alarm
to sound. To mute this alarm in CVCF mode, use
the software.
3.6.4 Other modes
To mute the audio alarm in any other mode, press
the ON button for less than half (0.5) a second.
You can enable the audio alarm again by pressing
the ON button for less than half (0.5) a second
again. If the new warning or fault alarm appears,
the buzzer will beep again.
—
3.6 Alarm mute function
3 GETTING STARTED
To Next Page
Loading...
