18
POWERVALUE 11T G2 1-3 KVA B/S
—
12 The LCD display panel
—
5 LCD settings
You can use the LCD module to access the
settings for each operating mode.
The available modes are displayed in the center
oval. Table 11 below shows the different display
name acronyms for each mode.
—
Table 11: LCD mode setting options
String Meaning Setting Options
OPV Output voltage
Voltage options are:
•
•
•
OPF Output frequency
Frequency options are:
•
•
bYPA Bypass status
•
Bypass Disable.
•
Bypass Enable.
• UPS will enter bypass mode
after several seconds if
Bypass Enable is selected.
• UPS will turn to no output
mode after several seconds
if Bypass Disable is selected.
MOdE Operating mode
• UPS—Normal operating
mode
• ECO—High-efficiency
mode
• CVF—Converter mode
EbPN
External battery
pack number
•
•
external battery packs.
bATT
Battery remaining
time
Battery time values are:
•
time function is disabled
and will not display on LCD
in battery mode.
•
time function is enabled,
and the time will display
(minutes or seconds) in
battery mode or battery
test mode. bATT will
CHG Charger current
•
•
5.1.1 Navigating the LCD
To access settings mode on the LCD display
panel, press the “Enter” button for more than
1 second.
The above modes are displayed individually in the
center oval. You can cycle through each mode by
pressing and holding “Enter” and then pressing
“Select.”
—
5.1 LCD setting overview
—
12
To Next Page
Loading...
