1MRK 505 353-UEN Section 1
Introduction
Application Manual 5
Bay protection functions REB500
• HMI menu paths are presented in bold, e.g.:
Select Main menu/Settings.
• LHMI messages are shown in Courier font, e.g.:
To save the changes in non-volatile memory, select Yes and ….
• Parameter names are shown in italics, e.g.:
The function can be enabled and disabled with the Operation setting.
• The * character after an input or output signal name in the function block
symbol given for a function indicates that the signal must be connected to an-
other function block in the application configuration to achieve a valid applica-
tion configuration.
To Next Page
Loading...
