Section 3 1MRK 505 353-UEN
Configuring bay protection using HMI500
18 Application Manual
Bay protection functions REB500
Section 3 Configuring bay protection using HMI500
3.1 Integration of bay protection
The REB500 bay models include no bay protection functionality. The integration
of the bay protection (variant V-L2) takes place under the setfile engineering dur-
ing the “Import a Bay Model” process.
The dialogue “Bay model import options” enables the selection of the BP variant
V-L2. After pressing the OK button, the respective bay is imported to the single-
line diagram and the selected BP variant (comprising the “V-L2 set” of BP func-
tions) is available for further configuration.
Figure 2 Selection the import option “Bay protection and “Variant””
For detailed information about the setfile engineering refer the REB500 Engineer-
ing Manual Section “single-line diagram”
The setfile engineering and the integration of the Bay protection re-
quires that the HMI500 is started under der “Configurator Mode”.
After that, the configuration details can also be adjusted under the
“Operator Mode”.
To Next Page
Loading...
