ABB REB500 - Configuring the Bay Protection Using HMI500; Select Protection Function

1MRK 505 353-UEN Section 3
Configuring bay protection using HMI500
Application Manual 19
Bay protection functions REB500
3.2 Configuring the bay protection using HMI500
To configure and set the bay protection function, open the HMI500 menu “Set-
tings” and select the menu item “Bay protection”.
Figure 3 Settings / Bay protection Configuration
Table 36 “Bay protection – Configuration” - buttons
Button Function
Continue
Ope
n
s
the dialogue “Select Protection Function” of
a
selected
b
ay
and
thus the BP configuration.
Instead of “Continue” button
,
si
mply double click a unit line
Copy
Co
pies the BP configuration of a
selected bay
Paste
Pastes the copied
BP configuration to a
selected bay
Delete configuration
Delete the BP configuration
of the selected bay
3.3 Select Protection Function
This dialog is divided into the following parts:
The protection functions available for configuration are listed on the left (in the
form of buttons). Its content is determined by the already selected Bay protection
variant (see Section 3.2).
The protection functions used for configuration are listed on the right. The first is
always the binary output function “BP output” (see Figure 4).