38
1MRS750527-MUM
)HHGHU7HUPLQDO
Technical Reference Manual, General
5()B
1)
These digital inputs can be programmed as either digital inputs or pulse counters, refer to section
“Pulse counters” on page 39.
)LOWHUWLPHRIDGLJLWDOLQSXW
The filter time eliminates debounces and short disturbances on a digital input. The
filter time is set for each digital input of the REF 54_ feeder terminal. The operation
of input filtering is illustrated below.
)LJ )LOWHULQJRIDGLJLWDOLQSXW
In the figure above, the input signal is named ‘Input’, the filter timer ‘Filter Time’
and the filtered input signal ‘Filtered Input’. At the beginning, the input signal is at
high state, the short low state is filtered and no input status change is detected. The
low state starting from the time t
0
exceeds the filter time, which means that the
change in the input status is detected and the time tag attached to the input change is
t
0
. The high state starting from t
1
is detected and the time tag t
1
is attached.
Each digital input has a filter time parameter “Input # filter”, where # is the number
of the digital input of the module in question (e.g. Input 1 filter).
1)
In the feeder terminal revisions of the Release 2.5 or later. Before Release 2.5: 1...65535 ms.
BIO2_7_BI7
BIO2_7_BI8
BIO2_7_BI9
BIO2_7_BI10
Digital inputs /
total
15 25 34
7DEOH 'LJLWDOLQSXWVDYDLODEOHIRUWKH5()B
5() 5() 5()
3DUDPHWHU 9DOXHV 'HIDXOW
Input # filter
1....15000 ms
1)
5 ms
t
0
t
1
dipo
Filter Time
Filtered Input
Input
Filter Time
To Next Page
Loading...
Need help?
General
