GUID-D6A397FC-EF84-4C5D-BA21-AA7B909FCBED V1 EN
Figure 15: View I/O page
4.5.5 Testing binary outputs
BIO-Tester provides LED indication next to each binary output. When a binary output
is activated from the LHMI, its LED lights up. This way, the status of activated binary
outputs can be monitored on BIO-Tester.
If the contact type of the binary output is “Normally Open / Normally Close” (NO/
NC), its LED is yellow to indicate “Normal” mode and green when they are activated.
If the binary output type is “Normally Open” (NO), activation of such a contact is
indicated by a green LED.
Table 7: LED status of outputs
LED
Color Decsription
Off -
Yellow Normal mode (NO/NC)
Green Activated (NO)
Activated (NO/NC)
Internal fault signal output (change-over/form C) IRF is a single contact included in
the power supply module of the protection relay. This IRF NO / NC type contact is
shown green when it is in “Normal” mode and when it is activated, the LED is shown
as red.
2NGA000105 B Section 4
BIO-Tester Relion® REX640
BIO-Tester Relion® REX640 29
User Manual
To Next Page
Loading...
