1MRS750915-MUM
REM 54_
31
Machine Terminal
Technical Reference Manual, General
5.1.1.4. Condition monitoring functions
The condition monitoring function blocks are documented on the CD-ROM
Technical descriptions of Functions.
5.1.1.5. Communication functions
In a customer-specific machine terminal configuration, special events can be
generated via an EVENT230 event function. EVENT230 is documented on the
CD-ROM Technical descriptions of Functions.
For more information about communication in the REM 54_ machine terminal, refer
to section “Serial communication” on page 70.
5.1.1.6. General functions
The general function blocks are documented on the CD-ROM Technical
Descriptions of Functions.
Table 5.1.1.4-1 Condition monitoring functions available for REM 54_
Function Description
CMBWEAR1 Circuit-breaker electric wear 1
CMBWEAR2 Circuit-breaker electric wear 2
CMCU3 Supervision function of the energizing current input circuit
CMGAS1 Gas pressure monitoring 1
CMGAS3
a
a. This function is only supported in Release 2.0 or later, refer to section “Revision identification” on
page 97.
Three-pole gas pressure monitoring
CMSCHED Scheduled maintenance
CMSPRC1 Spring charging control 1
CMTCS1 Trip circuit supervision 1
CMTCS2 Trip circuit supervision 2
CMTIME1 Operate time counter 1 for the operate time used (e.g. motors)
CMTIME2 Operate time counter 2 for the operate time used (e.g. motors)
CMTRAV1 Breaker travel time 1
CMVO3 Supervision function of the energizing voltage input circuit
Table 5.1.1.6-1 General functions available for REM 54_
Function Description
INDRESET Resetting of operation indicators, latched output signals, registers
and waveforms i.e. the disturbance recorder
MMIWAKE Activation of HMI backlight
SWGRP1 Switchgroup SWGRP1
SWGRP2 Switchgroup SWGRP2
SWGRP3 Switchgroup SWGRP3
......
SWGRP20 Switchgroup SWGRP20
To Next Page
Loading...
