ABB REM 543 - LON Network Configuration

36
1MRS750915-MUM
Machine Terminal
Technical Reference Manual, General
REM 54_
A060249
Fig. 5.1.2.2.-2 Alarm channel configuration
Interlocking LED texts can also be defined in the view illustrated above, but the
interlocking LED colours cannot be changed. For the operation of the interlocking
LED, refer to section “Interlocking” on page 80.
For more information about the use of the editor, refer to the Relay Mimic Editor
manual (see “Related documents” on page 10).
5.1.2.3. LON network configuration
The LON Network Tool is used for binding network variables between RED 500
terminals. Typically, LON is used for transferring status data between the terminals
for interlocking sequences running in the units, refer to chapter 5.1.2.3.-1 below and
Figure 5.1.13.8.-1 on page 75.
A050183
Fig. 5.1.2.3.-1 Communication between RED 500 terminals in station interlocking
For more information about the use of the tool, refer to the LNT 505 Operator’s
Manual (see “Related documents” on page 10).
>1
nv_state
RE_ 54_
nv_state
nv_state
>1
nv_state
RE_ 54_
nv_state
nv_state
>1
nv_state
RE_ 54_
nv_state
nv_state
LON
Inter-
locking
Blocking
Open
enable
Close
enable
Close
Open
Reserve
Inter-
locking
Blocking
Open
enable
Close
enable
Close
Open
Reserve
Inter-
locking
Blocking
Open
enable
Close
enable
Close
Open
Reserve
Comm_In
Comm_Out
Comm_In
Comm_Out
Comm_In
Comm_Out
I/O I/O
I/O