Cutting Tool Operating Guide 7
5. Assembling the cutting tool
1. Install the feed rod (2) to the power unit (1).
Tighten the feed rod to the power unit so
that all the feed rod threads are inside the
power unit.
Figure 9: Assembling the cutting head
1. Power unit
2. Feed rod transmitting power to the punching head
3. Punch
4. Cutting head ID. When assembled correctly, the same text should appear in both the die and punch.
5. Coil springs (2 pcs). The punch moves backwards to the starting position when the vent lever is pressed.
6. Die
7. Nut holding the cutting head parts together
8. Lock pin for locking the nut
9. Gatherer for collecting offcuts
10. Gatherer fixing screws (2pcs).
11. Cutting head including eight parts
1
11
10
2
3
4
9
4
8
5
6
7
To Next Page
Loading...
