&DOLEUDWLRQ
3.2.3. Calibration, all axes, CalPend
413HAC 16578-1 Revision: E
© Copyright 2003-2007 ABB. All rights reserved.
6. Click 2..
A number of menus will flash by briefly
on the teach pendant unit, but no action
is required on behalf of the operator until
a specific action is displayed.
7. Confirm the position of all calibrated
axes when the calibration has been
performed satisfactorily.
Detailed in section 3RVWFDOLEUDWLRQSURFHGXUH
RQSDJH.
8. Disconnect all calibration equipment and
refit all protective covers.
$FWLRQ 1RWH
&RQWLQXHG
To Next Page
Loading...
