ABB S4Cplus

3UHSDULQJWKHHTXLSPHQW
2.2. Start up of Levelmeter 2000
3HAC 16578-1 Revision: E30
© Copyright 2003-2007 ABB. All rights reserved.
6WDUWXSRI/HYHOPHWHU
/D\RXWDQGFRQQHFWLRQRI/HYHOPHWHU
The figure below shows the layout and connection of the Levelmeter 2000.
xx0200000126
3UHSDUDWLRQVVHWWLQJRI/HYHOPHWHU
The procedure below details the initial preparations of the Levelmeter.
6WDUWXSRI/HYHOPHWHU
Shown below is an outline of how to initialize the Levelmeter 2000. Detailed procedures are
specified in the manual supplied by the manufacturer.
A Connection sensor A
B Connection sensor B
C Connection SIO 1
D Selection pointer
E Measuring unit
ABC
E
D
$FWLRQ
1. Warm up the Levelmeter 2000 for at least 5 minutes before use, if turned off.
2. Set the measuring unit of the angle (DEG) to a sensibility of three decimals, e.g. 0.330º.
$FWLRQ 1RWH
1. Connect the measuring unit and sensor using
the included cables.
2. Power up the Levelmeter 2000. Power sources are detailed in 3RZHU
VRXUFHVRI/HYHOPHWHURQSDJH.
3. Connect sensors A and B. Detailed in ,GHQWLI\VHQVRUVRQSDJH.
&RQWLQXHVRQQH[WSDJH