ABB S4Cplus

*HQHUDOLQIRUPDWLRQ
1.6. Storage and warm up
3HAC 16578-1 Revision: E28
© Copyright 2003-2007 ABB. All rights reserved.
6WRUDJHDQGZDUPXS
127(
Always store the pendulum sensor in its carrying bag laying down or mounted on the
calibration plate in a horizontal position.
6WRUDJHLQDQRQKRUL]RQWDOSRVLWLRQPD\FDXVHORQJWHUPGULIWDQGHUURUVLQWKH:\OHU
VHQVRUV
6WRUDJHDQGZDUPXS
After storage the pendulum tool must be mounted in a horizontal position and be warmed up
(power on) for at least 5 minutes before use.
Storage position or warm up position is illustrated below
xx0300000152
A Calibration pendulum 3HAC 4540-1
B Calibration plate 3HAC 020552-002