ABB S800 - Page 15

Electrostatic Sensitive Device
Devices labeled with this symbol require special handling precautions as
des
cribed in the installation section.
3BSE015969-600 A 15
Safety Summary
GENERAL
WARNINGS
Equipment Environment
All components, whether in transportation, operation or storage, must be
in a no
n-corrosive environment.
Electrical Shock Hazard During Maintenance
Disconnect power or take precautions to insure that contact with ener-
gized parts is avoided when servicing.
SPECIFIC
WARNINGS
Page 109: In I.S. applications, modules with I.S. Interfaces MUST be
mounted right most of the I/O station or as a separate group.
The installation must be performed by qualified personnel. It must comply
with the relevant national/inter
national standards (e.g. IEC 79-14, CEI
64-2, BS 5345 Pt. 4, DIN VDE 165) and in-line with the established instal-
lation rules and recommended practice (e.g. CEI 64-8, ANSI/ISA
RP-12.6). The conformity of hazardous area field devices with the related
system documentation must
always be checked.
When using modules with I.S. Interfaces
in non I.S. applications, the I.S.
modules can be placed in any position following the same rules as non
I.S. modules.
SPECIFIC
CAUTIONS
Page 121: The calculated load of Advant Fieldbus 100 must be equal to
or less than 70%.
Page 123: The calculated load of Advant Fieldbus 100 must be equal to
or less than 50%. NOTE! 1 ms c
ycle time is not allowed.
Page 124: The calculated load of Advant Fieldbus 100 must be equal to
or less than 50%. NOTE! 1 ms c
ycle time is not allowed.