ABB SACE Emax E6.2 - Circuit-Breaker Dismantling Operations

ABB | SACE Emax 2
Accessories | 1 - Preliminary considerations
155 | © 2013 ABB | 1SDH001000R0002 - L7804
Circuit-breaker dismantling
operations
To dismantle the accessories, the following parts must be removed from the circuit-breaker:
• Transparent flange (A) of the release, by turning the screws (B).
• Escutcheon plate of the circuit-breaker (C), by removing the mounting screws (D).
A
D
B
C
2
1
90°
1
2
Figure 85 - Removing the flange and escutcheon plate
After reassembling the accessories, the parts previously disassembled must be reassembled
as indicated:
• Escutcheon plate of the circuit-breaker (C), by screwing in the mounting screws (D). Tighten
with tightening torque 1.1 Nm.
• Transparent flange (A) of the release, by turning the screws (B).
A
D
B
C
1
90°
2
1
2
Figure 86 - Assembly of flange and escutcheon plate