ABB SAM600 - Page 60

Event name Severity Status Description Required action
Reset to
factory
defaults
Informati
on
ON only Created when the
configuration of a module is
erased.
None
New system
time set
Informati
on
ON only Created when the new
system time is set on the
SAM600-TS module.
None
Event log reset Informati
on
ON only Created when the event log
on SAM600 module is
deleted.
None
Serial
communication
failure
Error ON only Created when the module
fails to receive a command
from the configuration tool
on its serial port, or when
the module fails to send a
command to the
configuration tool from its
serial port.
Check the
module’s serial
port connection.
If an error occurs,
call for help.
New DSP
firmware was
loaded to the
module
Informati
on
ON only Created at module startup
when a change of firmware
version is detected, e.g. after
a firmware upgrade.
None
New FPGA
firmware was
loaded to the
module
Informati
on
ON only Created at module startup
when a change of firmware
version is detected, e.g. after
a firmware upgrade.
None
Configuration
apply failed
Error ON only Error log is created when the
module could not correctly
apply the settings of the
configuration.
If the error
persists after
writing the
configuration
again to the
SAM600 system,
call help line.
Section 8 1MRK 511 434-UEN B
System Log Events
52 SAM600 Process Bus I/O System
Operation Manual
© Copyright 2017 ABB. All rights reserved