ABB Totalflow NGC8206 User Manual

MEASUREMENT & CONTROL SYSTEMS
NGC8206 Start-Up Guide

ABB Totalflow NGC8206 Specifications

General

Brand	ABB
Model	Totalflow NGC8206
Category	Laboratory Equipment
Language	English

Summary

NGC Installation and Start-Up Procedures

Introduction and Preparation

Overview of the guide, copyright notice, and pre-installation checks.

Site Selection and Mounting

Guide on selecting an installation site and physically mounting the NGC unit.

Sample Conditioning and Stream Connections

Installing sample conditioning modules and connecting sample streams.

Gas Lines, Power, and Leak Checks

Connecting vents, gas lines, power, and performing leak checks.

Voltage Adjustment and Power Application

Setting power source voltage and applying DC power to the unit.

Software Installation and Local Connection

Installing PCCU32 software and connecting the NGC unit.

NGC Start-Up Wizard and Calibration

Using the Start-Up Wizard, calibrating, and verifying settings.

Unit Operation and Sequence Verification

Verifying stream sequences and placing the unit in run mode.

Remote Communication

Communication Port Configuration

Details on communication port pin-outs and termination.

NGC Troubleshooting Guide

Communication and Start-Up Issues

Diagnosing communication problems and resolving start-up configuration errors.

Peak Analysis and Calibration Errors

Troubleshooting peak identification, calibration data, and sequence verification.

Operational Performance Tuning

Solutions for oven stabilization, carrier pressure, gating, and flow duration.