ABB TPL67-C Series

Operation Manual / TPL67-C.. - TPL71-C..
Maintenance
5
Cleaning the com
pressor during
operation
5.3
Page 60
© Copyright 2017 ABB. All rights reserved.
February 2017 HZTL2488_EN Revision D
Wet cleaning using external water-pressure vessel (XC3)
Operating state prerequisites for wet cleaning XC3
NOTICE
To be able to carry out a satisfactory cleaning process which has been
tested and is recommended by ABB Turbo Systems, the following pre-
requisites must be fulfilled:
 Engine load 50 ... 85%
 Start of cleaning cycle in accordance with following description for
wet cleaning operation with XC3.
Operating procedure for compressor wet cleaning with XC3
 The operating state prerequisites for compressor cleaning with XC3
must be fulfilled.
 Remove sealing plug (X).
 Fill vessel with required volume of clean water (see
table Cleaning pa-
rameters
).
5.3.2
Operating the water
pressure vessel