ABB TPU - Page 18

18
CURRENT AND VOLTAGE INSTRUMENT TRANSFORMERS
INSTRUCTIONS FOR INSTALLATION, USE AND MAINTENANCE
3) Handling by the self-locking hooks




to grip the hooks under the base of the trans

Note. This system is recommended for types:

KGUG, KGUGI. This handling system is visualized
on the pictures.
Safety warning! 
and the crane has to be 200 kg at least. Always
make sure that the hooks hold safely on the
crane and on the transformer.
4) Handling by the self-locking hooks under pri-
mary screws




dling can be done by hanging of the hooks on the

Note. This system is recommended for types:
-
sualized on the picture.
Safety warning! 
and the crane has to be 200 kg at least. Always
make sure that the hooks hold safely on the
crane and on the transformer.
 During the manipulation with
transformer it is necessary to follow safety work
instructions. Never stand under the freight. Al-
ways make sure that the freight is safely locked
on the crane and make sure that there is no risk
of unexpected release or turnover of the freight.
Note. Holding jigs, described in these chapters,
are not a part of delivery.
—
13 Self locking hooks
attached on the
handling grips
—

attached under
primary screws
—
14
—
13