34
Handling by rollers
Lift the switchgear section by overhead or mobile
crane or using jacks; remove the wooden pallet
loosening the screws fixing it to the switchgear
section base. Put a sturdy metal sheet between
the rollers and the panel base and place the
switchgear on the sliding rollers.
WARNING
Only use rollers on a level floor. Move the
switchgear section avoiding any possible tilting.
Handling by transpallet or fork lift trucks
To guarantee stability, the switchgear must not
be lifted too high. Check the alignment of the
forks.
WARNING
Only use transpallets or fork lift trucks on a level
floor. Move the switchgear section avoiding any
tilting.
—
5. Dispatch and storage
Figure 39: Handling the switchgear in the wooden crate
Figure 40: Lifting switchgear packed in a wooden crate
Figure 41: Handling by rollers
Figure 42: Switching handling
1 Sliding rollers
2 Metal sheet
To Next Page
Loading...
