LVD-EOMU02U-EN REVB 04/2022
3.5 Setup, data mapping and typical parameters for ACH580 and ACH580 E-Clipse bypass
ACH580 ACH580 E-Clipse
Drive Parameter ACH580 E-Clipse
Setup parameters
Note: You MUST set 58.06 to refresh settings after all parameters in group 58 are set.
Note: ACH580
E-Clipse power must be cycled for changes to take effect
ACH580 E-Clipse typical parameters
READ from VFD
WRITE to VFD
Drive Parameter Example for ACH580
Setup parameters
ACH580 typical parameters
READ from VFD
Write to VFD
To Next Page
Loading...
