Need help?Do you have a question about the ABB Welcome and is the answer not in the manual?
Provides a table to calculate consumer units for the system controller.
Offers a table for calculating consumer units for auxiliary power supplies.
Details system planning for various multifamily house setups with consumption calculations.
Guides on setting up a reliable, simple, and future-oriented ABB-Welcome system.
Describes modernizing existing intercom systems with ABB-Welcome.
Explains converting old bell systems in one-family and multifamily houses.
Provides instructions for mounting outdoor stations, including flush and surface mounting.
Details the installation process for various indoor station types.
Covers the mounting and wiring of system devices like distributors and actuators.
Explains address setting and button sound on/off for outdoor stations.
Details factory and offset assignments of doorbell buttons to apartments.
Guides on setting indoor station addresses and designating standard outdoor stations.
Explains how to designate a main indoor station within an apartment.
Covers setting terminal resistors and door opener/light switch functions.
General| Display | 7-inch TFT LCD |
|---|---|
| Resolution | 800 x 480 pixels |
| Installation | Wall-mounted |
| Operating Temperature | +55°C |
| Wiring | 2-wire |
| Connectivity | Ethernet |
| Housing Protection | IP54 |
| Power Supply | 24 VDC (supplied by system controller) |
To Next Page
