42 | XSERIES G5 START UP GUIDE | 2106001MNAA
Figure 6-1: XFC Display startup messages (part numbers are examples)
IMPORTANT NOTE: If the LCD fails to display the startup
sequence, see section 13: Troubleshooting
.
Power with battery and charger
Operating in battery power mode requires a 12 volt sealed lead acid (SLA)
battery and a charger to recharge the battery. This mode requires
connection of the battery and the charger. The battery and charger must
be installed. See section 3 Install battery and charger
. Adapt these
instructions for alternate installations.
Connect the battery (dc power)
Connect the 12 volt SLA battery using the battery cable.
WARNING– Bodily injury and property damage. Complete all
wiring of peripheral or external devices to the controller
before power is applied.
Connect the battery before connecting the charger cable.
Connect the battery:
To Next Page
Loading...