ABB X Series G5 - Connect the Charger; Connect Solar Panel Charger

2106001MNAA | XSERIES G5 START UP GUIDE | 43
1. Connect the battery to the BATT terminals on the XFC (J1 as shown
below) or XRC (J16). Observe the polarity (+ and -).
Figure 6-2: XFC BATT connector
2. Confirm that the battery is supplying power to the XFC or XRC by
observing the power-on sequence information scrolling on the LCD
(see details in Section 6.1 Super capacitor charging at boot time
).
3. If the power-on sequence fails to initiate or complete, press the
reset button (shown below).
Figure 6-3: Reset button and coldboot button
Connect the charger
NOTICE – Equipment damage. Always connect the battery to the
BATT port before connecting the solar panel or alternate charger
cable to the XFC or XRC.
Connect the solar panel charger:
1. Reinsert the CHRG connector wired to the charger cable to the
CHRG terminal on the XFC (J5 shown below) or XRC (J17).