CODE
XXX
CODE
A
b
Sensor Pack | Envase del sensor
Customer Service | Atención al clien
1-855-632-8658
XXXXXXXXXXX
XXX
YYYY-MM-DD
F
r
e
e
S
t
y
l
e
L
i
b
STEP 3
STEP 6
STEP 9
Get ReadyApply Sensor Prepare Sensor Applicator
Wash site using a plain soap,
dry, and then clean with alcohol
wipe. Allow site to air dry before
proceeding.
Peel lid completely o Sensor Pack.
Unscrew cap from Sensor Applicator.
CAUTION: Sensor codes
must match on Sensor Pack
and Sensor Applicator or
glucose readings will be
incorrect.
Refer to your User’s Manual for full System instructions and information.
Touchscreen
Home Button
USB Port
Sensor
Pack
Reader
Place Sensor Applicator over site
and push down rmly to apply
Sensor.
CAUTION: Do not push down on
Sensor Applicator until placed
over prepared site to prevent
unintended results or injury.
Make sure Sensor is secure.
Discard used Sensor Applicator
and Sensor Pack according to
local regulations.
Gently pull Sensor Applicator
away from your body.
Quick Start Guide for
FreeStyle Libre 2 Reader
STEP 1
STEP 4
STEP 7
STEP 2
STEP 5
STEP 8
Line up dark mark on Sensor
Applicator with dark mark on
Sensor Pack. On a hard surface,
press down rmly on Sensor
Applicator until it comes to a stop.
Sensor Applicator is ready to
apply Sensor.
CAUTION: Sensor Applicator
now contains a needle. Do not
touch inside Sensor Applicator
or put it back into Sensor Pack.
Lift Sensor Applicator out of
Sensor Pack.
Lid
Cap
Sensor
Sensor
Applicator
Codes on labels
must match
●
1 Assemble and Apply
Sensor to your body
●
2 Start new Sensor with Reader
●
3 Check your glucose whenever you
want for up to 14 days.
Wait 60 minutes
for start-up
Select site on back of upper arm.
Do not use other sites as these may
result in inaccurate glucose readings.
Note: Avoid scars, moles, stretch
marks, lumps, and insulin injection
sites. To prevent skin irritation,
rotate sites between applications.
Setup Overview
●
1 Assemble and Apply Sensor to the back of your upper arm
FLASH GLUCOSE MONITORING SYSTEM
To Next Page
Need help?
General
