What to do if Abbott FreeStyle Libre Reader does not power on?
If your Abbott Blood Glucose Meter Reader doesn't power on, it could be due to a low battery. Try charging the Reader. Alternatively, the Reader might be outside its operating temperature range. Move the Reader to a location where the temperature is between 10°C and 45°C and then attempt to power it on.
Why is Abbott FreeStyle Libre Blood Glucose Meter Sensor not sticking to my skin?
If the Abbott Blood Glucose Meter Sensor is not sticking to your skin, it may be because the application site is not free of dirt, oil, hair, or sweat. Remove the Sensor, clean the site with plain soap and water, consider shaving the area, and then follow the instructions in the Applying and Starting Your Sensor sections to reapply the sensor.
What to do if Abbott FreeStyle Libre does not power on?
If your Abbott Blood Glucose Meter does not power on after you press the Home Button or insert a test strip, the Reader battery might be too low; in this case, charge the Reader. Alternatively, the Reader might be outside of its operating temperature range. Move the Reader to a temperature between 10 °C and 45 °C and then try to power it on.
General| Sensor Wear Duration | 14 days |
|---|---|
| Scan Time | 1 second |
| Meter Category | Continuous Glucose Monitoring (CGM) |
| Name | FreeStyle Libre |
| Operating Temperature | 10°C to 45°C |
| Water Resistance | IP27 |
| Glucose Range | 500 mg/dL |
| Measurement Range | 500 mg/dL |
| Warm-up Time | 1 hour |
| Compatibility | FreeStyle Libre Reader |
Specifies the age group and conditions for which the system is intended.
Lists conditions or situations where the system should not be used.
Describes the contents and features of the Reader Kit.
Describes the contents and features of the Sensor Kit.
Instructions for correctly attaching the sensor to the body.
Guide on activating the sensor with the Reader.
Procedure for scanning the sensor and obtaining glucose readings.
Displays a chronological list of all glucose and ketone tests.
Shows glucose readings over a 24-hour period graphically.
Provides summary statistics like averages and patterns over time.
Procedure for testing blood glucose using the Reader's meter.
Procedure for testing blood ketone levels using the Reader's meter.
How to perform tests to verify meter and strip accuracy.
Solutions for when the Reader fails to turn on.
Addresses issues with sensor adhesion and skin irritation.
Solutions for sensor activation and data reception errors.
Explains error codes and recommended actions for glucose/ketone tests.
Solutions for problems encountered during blood glucose/ketone checks.
How to run a diagnostic test on the Reader's functionality.
Information on how to contact support for assistance.
How to set insulin dose increments (e.g., 0.5 or 1 unit).
Guide for configuring the insulin calculator settings.
Instructions for modifying previously set insulin calculator parameters.
Technical characteristics and parameters of the sensor.
Technical characteristics and parameters of the Reader device.
Technical parameters and ranges for the insulin calculator.
To Next Page