Abbott FreeStyle Navigator - Unlinking Procedure

Steps Do This
1. Decide what you want to do.
2. Unlink your receiver from
your transmitter.
a. Press the RIGHT Option button twice to display the
Main menu.
b. Use the UP or DOWN Arrow button to highlight
System.
c. Press the RIGHT Option button (Select) to display the
System menu.
d. Use the UP or DOWN Arrow button to highlight Link.
e. Press the RIGHT Option button (Select) to display the
Link screen.
f. Press the LEFT Option button (Unlink) to unlink your
transmitter from your receiver.
Note: Unlinking your receiver from your transmitter
will terminate your sensor. If you proceed, you will
need to insert a new sensor aer linking to your new
transmitter. A warning screen is displayed if you have
a sensor in progress. Press the button labeled “Yes” to
continue unlinking.
g. Press the LEFT Option key (BG) to operate your
system in the Blood Glucose mode. By choosing this
option, you have shut o the Continuous Monitoring
mode.
Note: You can now use your receiver to perform blood
glucose measurements (See Section 7).
h. Go to Step 1 to decide what to do next.
•Unlinkyourreceiverfromyourtransmitter.
2
•Linkyourreceivertoyourtransmitter. 3
•Checkyourwork. 4
If you want to
en go
to Step
Customer Care: 1-866-597-5520
132 Section 14
Link and Unlink Your Transmitter and Receiver
Link 08:30A
Blood Glucose Mode
or
Relink to Transmitter
BG Relink