Abbott FreeStyle Navigator - First-Time Setup

How do I prepare my system for the rst time?
When you are setting up your receiver for the rst time, perform all of the procedures listed below in the
order that they are listed. Check each procedure o when you complete it.
o
Install batteries in the transmitter rst and then in the receiver (see Section 2).
o
Set the time and date (see Section 3).
o
Perform a control solution test (see Section 4).
o
Insert your sensor (see Section 5).
o
Attach your transmitter (see Section 6).
o
Calibrate your receiver when prompted (see Section 7).
o
Set the alarms in the receiver (see Section 8). Note: is can be done while waiting to perform the
rst calibration.
Result: Your system is operational.
Customer Care: 1-866-597-5520
6 Section 1
Getting Acquainted