Steps Do This
5.
Check your work.
Result: A transmitter ready to send glucose data.
You have done this procedure correctly when:
o
e transmitter is securely attached to the sensor
support mount.
o
You have applied an over-bandage as necessary to
hold down the transmitter and the sensor support
mount.
o
e sensor code has been correctly entered into the
receiver.
o
You see an icon on the top right hand corner of
the screen.
END OF Section 6
Customer Care: 1-866-597-5520
50 Section 6
Attach Your Transmitter
To Next Page
Loading...
