4.3.3.1 Disconnection with bonded device
The usual BLE keepalive mechanism between the central device and the tracker is done at the frequency of
one message per second (Maximum connection interval).
The BLE connection is said lost if no messages are received for 6 seconds (Supervision timeout).
30 seconds after a secured connection is lost, the last configured operational mode of the tracker is restored.
4.3.3.2 Clear bond event
The bond information can be cleared by:
➢ A LoRa Downlink (see Debug command section for more details)
➢ A specific BLE command, (see details here)
Once cleared the tracker is disconnected from the central device and switches to its configured operational
mode.
The bonding procedure restarts.
4.3.4 Retrieve data from the tracker
4.3.4.1 Device Information
The tracker exposes the Device Information Service allowing a bonded Client application to read information
summarized in the table below:
To Next Page
Loading...