1-4 Chapter1
BE6
"
""
"
Supports Wake On LAN, Keyboard or Mouse, but your ATX power supply 5V
standby power must be able to provide at least a 720mA current capacity.
Otherwise, the functions may not work normally.
"
""
"
PCI slots 4 and 5 use the same bus master control signal.
"
""
"
PCI slot 3 shares IRQ signals with the HPT366 IDE controller (Ultra ATA/66). The
driver for HPT 366 IDE controller supports IRQ sharing with other PCI devices.
But if you install a PCI card that doesn’t allow IRQ sharing with other devices into
PCI slot 3, you may encounter some problems. Furthermore, if your Operating
System doesn’t allow peripheral devices to share IRQ signals with each other--
Windows NT for example, you can’t install a PCI card into PCI slot 3.
"
""
"
HPT 366 IDE controller is designed to support high-speed mass storage. Thus we
don’t suggest you connect non-disk devices that use ATA/ATAPI interfaces, such as
CD-ROM to HPT 366 IDE connector (IDE3&IDE4).
#
Above 66MHz/100MHz bus speeds are supported but not guaranteed due to the PCI and
chipset specifications.
#
Sound Blaster
™
is a registered trademark of Creative Technology Ltd. in the United
States and certain other countries. Sound Blaster - LINK
™
and SB-LINK
™
are
trademarks of Creative Technology Ltd.
#
Specifications and information contained in this manual are subject to change without
notice.
Note
All brand names and trademarks are the property of their respective owners.
To Next Page
Loading...
Need help?
General
