Safety and Operating Notices
4
• No parts to be maintained by the user are located inside the device.
• Only have qualified, specialist personnel repair and/or install the device.
WARNING!
This charging station is intended for connection to and operation on 230
/ 400 V 50 Hz mains power only. Power supply cables may be installed
below or above the wall surface. The cable should enter the device on
the underside of the bottom part of the housing (see page ii).
• Only use a dry cloth to clean the device. Do not use aggressive cleaning agents,
waxes or solvents (such as cleaning fluid or paint thinner), because they can dull
the displays on the device.
• The charging station MUST NEVER be cleaned using a pressure cleaner or similar
implement.
• Check the permanently installed charging cable of your eMH1 station regularly for
potential abrasions or damage.
DANGER!
Should you discover any damage to the charging cable or a supply
cable, you must take the device out of operation immediately. In this
case, please turn to an authorized service partner or the dealer from
whom you purchased the product. You must NOT UNDER ANY CIR-
CUMSTANCES attempt to resolve or repair any damage or malfunction
yourself!
• Relevant local regulations for operating electrical devices always apply.
To Next Page
Loading...
