PROBOIL.2X user & installation guide v1e-2
16. Wait for the PROBOIL.2X unit to display
“READY” onscreen
17. Take note of the time and wait for no longer than a further 10 minutes maximum for the sterilising liquid to
work. It is normal for an odour to be present during this time.
18. Turn the boiler back into standby mode
19. Turn on the 98°C tap handle on fully, keep the handle on for a minimum of 5 minutes.
20. Turn the boiler back on and set it to the
desired target temperature, wait until the
display shows “READY”.
21. If dirt, debris or taste remains then you can flush the tap for a further 5 minutes or repeat the process steps 1-20
again if needed.
To Next Page
Loading...