Why is water splashing sideways from the spout end of my Abode PROBOIL.2X?
If the spout aerator of your Abode Boiler may be blocked or calcified, see the “descaling- aerator” section for more detail.
What to do if the keys on my Abode PROBOIL.2X do not respond when touched?
If the keys on your Abode Boiler do not respond, clean the screen with a damp, soapy, non-abrasive cloth and dry it. Make sure your hands are dry when pressing the keys. Also, remove any clear film from the screen, if there is any.
Why is there a delay when starting the 98°C water flow from my Abode PROBOIL.2X Boiler?
If the 98°C water from your Abode Boiler doesn't start flowing immediately when you turn the handle on, it's normal. There is a short delay as the tap empties partly after each use.
Why is my Abode PROBOIL.2X Boiler dripping intermittently from the spout end aerator?
If water is dripping intermittently from the center or outer channel of the spout end aerator of your Abode Boiler, typically shortly after each use, it is normal. This is water retained within the spout falling due to gravity and is normal for any tap.
What does error “E” code mean on my Abode PROBOIL.2X?
To solve Error “E” code displayed on the screen of your Abode Boiler, fill / flush with water, message will self clear. For E5, E6, E7, E8, E9 contact service number on top of unit.
How to revert to normal mode on my Abode Boiler?
If your Abode Boiler display shows only a question mark, the unit is in standby mode. Press and hold the ? for 1.5 seconds to revert to normal mode.
How to fix a slow 98°C water flow rate on my Abode PROBOIL.2X (blocked inlet)?
If the water flow rate from your Abode Boiler is slower than expected, your boiler inlet could be partly blocked with debris. With the water isolated, remove the blue inlet wingnut (G) and inspect the meshed inlet seal (H) underneath; clean if required.
How to fix a slow 98°C water flow rate on my Abode PROBOIL.2X Boiler (blocked aerator)?
If the water flow rate from your Abode Boiler is slower than expected, the aerator on the tap end could be partly blocked with debris or calcified. Follow the aerator descale procedure in this manual.
How to fix a slow 98°C water flow rate on my Abode Boiler (calcification)?
If the water flow rate from your Abode Boiler is slower than expected, the boiler could be calcified. Follow the boiler descale procedure in this manual.
Why is the water temperature lower than expected in my Abode PROBOIL.2X Boiler after a power cut?
If the water temperature from your Abode Boiler is lower than expected after a power cut, the boiler automatically turns back on in standby mode. Press and hold the ? for 1.5 seconds to revert to normal mode. Follow the “Periods of non-use” guide to ensure water is heated.
Essential safety rules for operating the appliance safely.
Key electrical safety measures to prevent hazards.
Understanding the boiler's display, indicators, and touch controls.
Essential preparation steps and site checks before installation.
Detailed instructions for mounting and connecting the boiler unit.
Final checks and procedures to ensure the product functions correctly.
To Next Page
General