Why is the water temperature lower than expected in my Abode PROBOIL.2X Boiler after a power cut?
If the water temperature from your Abode Boiler is lower than expected after a power cut, the boiler automatically turns back on in standby mode. Press and hold the ? for 1.5 seconds to revert to normal mode. Follow the “Periods of non-use” guide to ensure water is heated.
Why does the silicone hose on my Abode PROBOIL.2X Boiler blow off when I turn on the tap?
If your Abode Boiler's silicone high temperature hose blows off, it may be due to incorrect installation of the steel braided flexible hoses. To check, disconnect the silicone outlet tube, turn the 98° tap handle slowly part on. If cold water comes out of the silicone high temperature hose, the installation is incorrect. Turn off the boiler power and have the installation checked and corrected.
What does it mean if the water temperature is lower than expected on my Abode PROBOIL.2X and the 'HEATING' indicator is on?
If the water temperature from your Abode Boiler is lower than expected and the “HEATING” indicator is still showing during use, it means the boiler has not completed its reheating cycle after its last use.
How to stop water dripping continuously from the outer channel of the Abode PROBOIL.2X spout?
To address water dripping continuously from the outer channel of the spout end aerator of your Abode Boiler, isolate the hot and/or cold water supplies leading to the tap, one at a time, to see if the dripping stops.
What to do if my Abode PROBOIL.2X is dripping continuously from the spout end aerator?
To resolve water dripping continuously from the center channel of the spout end aerator on your Abode Boiler: 1) Put the boiler into standby mode by pressing and holding the ? key for 1.5 seconds. 2) Turn the 98°C tap handle off fully. 3) If dripping continues, the boiling water valve needs replacement.
Why is the water temperature lower than expected on my Abode Boiler when it shows 'READY'?
If the water temperature from your Abode Boiler is lower than expected and the boiler shows “READY”, it might be because only a small amount of water has been used. It takes a few minutes for the boiler temperature to equalize and start its reheat cycle.
Why is my Abode PROBOIL.2X Boiler dripping intermittently from the spout end aerator?
If water is dripping intermittently from the center or outer channel of the spout end aerator of your Abode Boiler, typically shortly after each use, it is normal. This is water retained within the spout falling due to gravity and is normal for any tap.
Why is there a delay when starting the 98°C water flow from my Abode PROBOIL.2X Boiler?
If the 98°C water from your Abode Boiler doesn't start flowing immediately when you turn the handle on, it's normal. There is a short delay as the tap empties partly after each use.
What to do if the keys on my Abode PROBOIL.2X do not respond when touched?
If the keys on your Abode Boiler do not respond, clean the screen with a damp, soapy, non-abrasive cloth and dry it. Make sure your hands are dry when pressing the keys. Also, remove any clear film from the screen, if there is any.
Essential safety rules for operating the appliance safely.
Key electrical safety measures to prevent hazards.
Understanding the boiler's display, indicators, and touch controls.
Essential preparation steps and site checks before installation.
Detailed instructions for mounting and connecting the boiler unit.
Final checks and procedures to ensure the product functions correctly.
To Next Page
General