Abov A31G213CLN - Connect the Starter Kit to Your PC; PC Connection Via USB on the Starter Kit; Figure 11. Starter Kit and USB Connection

A31G213CLN Shield Board Quick Start Guide 3. Building and running project (Shield Board)
13
3.3 Connect the Starter Kit to your PC
3.3.1 PC connection via USB on the Starter Kit
Connect the USB 2.0 (micro-B type) cable to the Starter Kit as shown in Figure 11.
1. If the PC is properly connected, the USB Power LED will be turned on -①
2. The status LED on the A-Link board (debugger) will be turned on -②
Figure 11. Starter Kit and USB Connection