Need help?Do you have a question about the Abov MC96F6432Q and is the answer not in the manual?
General| Core | 8051 |
|---|---|
| Flash Memory | 64 KB |
| Package | LQFP-48 |
| PWM | Yes |
| UART | 1 |
| SPI | 1 |
| I2C | 1 |
| CPU Speed | 16 MHz |
| GPIO Pins | 36 |
| Operating Voltage | 2.4V to 5.5V |
| Timers | 3 |
| Operating Temperature | -40°C to 85°C |
| ADC | 12-bit, 8 channels |
Specifies the absolute maximum ratings for the device, beyond which permanent damage may occur.
Outlines the recommended operating voltage and temperature ranges for reliable device performance.
Provides DC electrical characteristics including input/output voltage levels, leakage current, and pull-up resistor values.
Provides the table of interrupt sources, their symbols, enable bits, priorities, and vector addresses.
Describes the clock generator, its overview, block diagram, and register map for system clock control.
Explains the 8-bit basic interval timer, its features, block diagram, and register descriptions.
Details the watchdog timer, its overview, timing waveform, block diagram, and register descriptions.
Covers Timer 0 overview, operating modes, 8-bit timer/counter mode, PWM mode, and capture mode.
Explains Timer 1 overview, operating modes, 16-bit timer/counter, capture, and PPG modes.
Details Timer 2 overview, operating modes, 16-bit timer/counter, capture, and PPG modes.
Describes Timer 3 and 4 overview, operating modes including 8-bit and 16-bit timer/counter, capture, and PWM modes.
Details the SPI 2 interface, its overview, block diagram, data transfer, SS2 pin function, and timing diagrams.
Covers the 12-bit A/D converter overview, conversion timing, block diagram, ADC operation, and registers.
Explains the USI0 module, its overview, UART mode, SPI mode, and I2C mode operations.
Details the USI1 module, its overview, UART mode, SPI mode, and I2C mode operations.
Introduces the power-down modes (Main-IDLE, Sub-IDLE, STOP) for minimizing power consumption.
Lists the five types of reset sources available for the MC96F6432.
Describes methods to protect flash memory from invalid erase/write operations.
To Next Page
