127
8.6.2 Cover Detection
With this menu item you can configure the camera so that video tampering is triggered as soon as the lens is
covered (so-called cover detection).
Area settings
Activate video tampering alarm by clicking the “Activate video tampering” checkbox.
To select an area, click on the "Draw Area" button. The entire area is selected by default. To discard this
selection, click on "Clear All".
Drag the mouse pointer over the desired area. Set the sensitivity using the regulation control bar. To apply the
setting for the area, click on "Stop Drawing".
Right: low sensitivity level.
Left: high sensitivity level.
Schedule
To save a schedule, click on "Activate schedule". Specify here on which days of the week and at which times
the function should be active.
The period selection is made by holding down the left mouse button. By clicking on an already marked period,
the details can also be set via keypad or deleted again.
To copy the time selection to other weekdays, move the mouse pointer behind the bar of the weekday already
set and use the "Copy to ..." function.
Apply the settings made by clicking "Save".
Apply the settings by clicking “Save”.
To Next Page
Loading...
Need help?
General
