141
8.7 Storage
8.7.1 Record schedule
Here, you can set the configuration for time and event-triggered recordings in order to be able to save them to
an SD card.
Post-record
Set the duration for recording of the image data after a basic event here.
Overwrite
Here, you can set whether the recordings should be automatically overwritten if the storage capacity is full.
Elapsed time: With this function it is possible to limit how long data is stored for on the SD card.
Schedule
To save a schedule, click on "Activate schedule". Specify here on which days of the week and at which times
the alarm output should be active.
The period selection is made by holding down the left mouse button. By clicking on an already marked period,
the details can also be set via keypad or deleted again.
To copy the time selection to other weekdays, move the mouse pointer behind the bar of the weekday already
set and use the "Copy to ..." function.
Apply the settings made by clicking "Save".
Under Record Type, select the recording mode for the desired schedule. You can
choose between the following recording types:
Normal: Continuous recording
Motion: motion-triggered recording.
Alarm: Alarm input (if available)
To Next Page
Loading...
Need help?
General
