129
Select the alarm type here. You can choose between “NO” (normally open) or “NC” (normally closed).
Schedule
To save a schedule, click on "Activate schedule". Specify here on which days of the week and at which times
the alarm input should be active.
The period selection is made by holding down the left mouse button. By clicking on an already marked period,
the details can also be set via keypad or deleted again.
To copy the time selection to other weekdays, move the mouse pointer behind the bar of the weekday already
set and use the "Copy to ..." function.
Apply the settings made by clicking "Save".
Linkage method
Here you can set the action to be performed when an event occurs.
Normal Linkage
Send email: You receive an email as notification; check the checkbox to activate this.
Notify the surveillance centre: If an event is triggered, the ABUS CMS software can be
informed. You may then get a picture pop-up, for example.
Uploading to FTP/Memory card/NAS: Check this check box to upload single frames to an FTP server,
the SD card or a connected NAS drive during an event.
Audible warning: This function can output preset or custom tones or sound media.
This requires a camera model with audio output or an integrated
loudspeaker.
Trigger alarm output
When an event is triggered, existing alarm outputs on the camera can be activated. The behaviour of the
alarm output can be set under "Events / Alarm output".
Trigger recording
Enable this in order to record motion detections onto an SD card.
Apply the settings by clicking “Save”.
To Next Page
Loading...
Need help?
General
