– 30 – – 31 –
By pressing the test/stop button, an alarm which has previously gone off can
still be identified: the alarm then beeps three times for one second.
The alarm memory function can be deactivated by pressing the test/stop
button.
Care and maintenance
What to do in case of false alarm?
Possible causes of false alarm include: Welding and cutting, soldering and
other hot work, sawing and grinding, dust created from building work, e.g.
cleaning, extreme electromagnetic effects, changes in temperature which lead
to condensation in the alarm as well as small insects and pollen.
• If a false alarm is being caused by work close to the device, it
should be temporarily covered up or removed. Upon completion of
the work, it is imperative, however, that the device be returned to
its original operating state and be checked!
Cleaning
The operation of every installed smoke alarm must be regularly checked and
kept safe through maintenance measures in accordance with German DIN
14676 application standards. This includes an inspection at least once every 12
months ± 3 months, including maintenance and checking the performance of
the warning signals. The results and measures taken should be documented
accordingly.
• Dust covered alarms must be cleaned. Dust deposits in the alarm’s
air vents can be sucked up or blown out.
• Dust can be removed with a brush if required.
• The surface area can be cleaned with a slightly damp and soapy
cloth.
• Take care that no liquids get into the apparatus!
Do not clean device in a dishwasher!
Display and functions Care and maintenance
• Do not use any sharp, pointed, abrasive or caustic cleaning
products, chemicals or hard brushes!
Maintenance
• The electronic components of each smoke alarm are subject to
ageing. In addition, insect screens and smoke measure chambers
will inevitably become contaminated over time.
• Operating life of the device:
The smoke alarm must be replaced no later than 10 years +
6 months after the manufacturing date.
Warranty
ABUS products are designed, manufactured and tested in accordance with
applicable regulations with great care. The warranty exclusively covers faults
that are caused by material or manufacturing defects. If a material or man-
ufacturing defect can be proven, the product will be repaired or replaced at
the discretion of the warrantor. In such cases, the warranty ends with the
termination of the original warranty period. Any further claims are expressly
excluded.
ABUS assumes no liability for defects or damage that has been caused by ex-
ternal inuences (e.g. transport, external forces), improper use, normal wear
and tear or non-compliance with this operating and installation instructions
document. If a warranty claim is asserted, the product must be returned with
the original receipt with date of purchase and a brief written description of
the fault.
Disposal
This product contains valuable raw materials. At the end of its service life,
dispose of the product in accordance with the applicable legal requirements.
Electrical appliances, rechargeable batteries and batteries must not be dispo-
sed of with household waste. Disposal must be carried out in accordance with
Directive 2012/19/EU on waste electrical and electronic equipment (WEEE),
Care and maintenance
GB
Warranty | Disposal
To Next Page
Loading...
Need help?
General
Weight and Dimensions
