9
2.2. Mounting & Installation
Test the release behaviour at the desired mounting
position in advance.
Installation site:
Optimum detection at an installation height of 180-240
cm.
Remove the safety strip from the battery compartment.
Fix the Mounting plate on the wall by screws
(recommended) or adhesive tape. Screw the detector
onto the mounting plate and ensure that the two holes
on the housing point downwards.
Note:
Do not mount the detector…
…opposite heat sources or windows
…less than 1m away from power or gas lines
…near electronic or wireless devices
…above heaters
…next to the floor
…near large metal structures
To Next Page
Loading...
