27
AUTO MODE (LOW HUMIDITY TRIGGER)
The AUTO Mode sets the low humidity trigger.
Your humidifier will activate if the probe’s
reading falls below this threshold.
Once triggered, your humidifier will ramp up to
the level set in ON Mode. If the probe’s reading
rises above this trigger point, your humidifier
will stop emitting vapors.
Leaving the AUTO Mode while it is active will
pause it until you return to this mode.
PROGRAMMING
LOW HUMIDITY
TRIGGER POINT
ON OFF
32 100
LESS HUMID MORE HUMID
55
If there is a level set in OFF Mode other
than zero, your humidier will run at
that level when triggered to turn o.
Screen shown: CLOUDFORGE T3
To Next Page
Loading...
