AC Infinity CLOUDFORGE - Page 28

28
HIGH VPD
ONOFF
TRIGGER POINT
HIGH VPD
LOW VPD
0
kPa
9.9
kPa
1.1kPa
PROGRAMMING
VPD MODE (HIGH VPD TRIGGER)
The VPD Mode sets the high VPD trigger. Your
humidifier will activate if the probe’s reading
meets or exceeds this threshold.
Once triggered, your humidifier will gradually
ramp up to the level set in ON Mode. If the
probe’s reading falls below this trigger point,
your humidifier will gradually slow down to a
stop or at the level set in OFF Mode.
Leaving the VPD Mode while it is active will
pause it until you return to this mode.
If there is a level set in OFF Mode other
than zero, your humidier will run at
that level when triggered to turn o.
Screen shown: CLOUDFORGE T3