Need help?Do you have a question about the AC Infinity CLOUDLINE T4 and is the answer not in the manual?
General| Type | Inline Duct Fan |
|---|---|
| Fan Size | 4 inches |
| Airflow (CFM) | 205 CFM |
| Voltage | 120 V |
| Bearings | Dual Ball Bearings |
| Motor Type | EC Motor |
| Controller | Included |
Step-by-step guide for physically mounting the fan unit, including disassembling and reassembling components.
Instructions on marking mounting locations and drilling holes, ensuring structural integrity of the mounting area.
Guidance on inserting wall anchors and securing the flange bracket to the wall using wood screws.
Steps for reattaching the wind circle, motor box, and securing them with metal clamps and checking airflow direction.
Instructions on using duct clamps to secure ducting to the fan for a tight seal.
Instructions on how to unscrew and rotate the motor cap to a desired orientation without voiding the warranty.
Guidance on using the fan as an intake or exhaust, and optimal placement within a grow space for ventilation.
Instructions for connecting the duct fan's UIS connector to the speed controller and plugging the fan into a wall outlet.
Steps for plugging the device's UIS connector into the controller and connecting the sensor probe for accurate readings.
Instructions for plugging the device into an AC power outlet and using tie mounts, screws, and zip ties for cord management.
How to control fan speed from 0-10 using the single button on the controller, including returning speed to 0.
Instructions on turning the fan OFF by holding the button for 4 seconds and turning it back ON to its last speed setting.
Details the various controller modes: PORT, MODE, SETTING, UP/DOWN, PROBE TEMP/HUMIDITY, CONTROLLER MODE, CURRENT LEVEL, PORTS, ALERT ICONS, COUNTDOWN, CURRENT TIME, USER SETTING.
Explains how to program devices individually via numbered ports or simultaneously using the ALL port setting.
Describes OFF MODE for minimum level setting and ON MODE for maximum level setting, impacting device operation.
Explains setting high and low temperature triggers for AUTO mode, controlling device activation based on probe readings.
Details setting high and low humidity triggers for AUTO mode, managing device activation based on probe humidity readings.
Explains TIMER TO ON and TIMER TO OFF modes, allowing devices to activate or deactivate after a set countdown.
Describes setting ON and OFF durations for devices to cycle continuously, with countdowns for each phase.
Details setting daily ON and OFF clock-times to schedule device activation and deactivation.
Customizes device ramp-up levels in AUTO MODE based on temperature, setting transition thresholds for smoother adjustments.
Customizes device ramp-up levels in AUTO MODE based on humidity, setting transition thresholds for smoother adjustments.
Determines the maximum level a device will run at when triggered ON, configured in ON MODE.
Sets the minimum level a device will continuously run at until triggered ON, configured in OFF MODE.
To Next Page