Need help?Do you have a question about the AC Infinity CLOUDLINE S6 and is the answer not in the manual?
General| Size | 6 inches |
|---|---|
| Voltage | 120V |
| Bearings | Dual Ball Bearings |
| Controller Type | PWM |
| Model | CLOUDLINE S6 |
| Type | Inline Duct Fan |
| Duct Size | 6 inches |
| Controller | Included |
Features PWM-controlled motor for precise speed, reduced noise, and energy efficiency.
Hydro-mechanical stator blades enable efficient airflow delivery in high static pressure environments.
Connecting multiple fans to the Controller 69 using its four ports.
Connecting devices using 2-port or 4-port dongles, with Port 1 as the primary device.
Controls fan speed from 0-10 via a single button, with speed increments and reset to 0 at max.
Sets high/low temperature triggers for device activation with gradual ramp-up/down based on ON/OFF modes.
Sets high/low humidity triggers for device activation with gradual ramp-up/down based on ON/OFF modes.
Allows setting countdowns for devices to turn ON or OFF at a specified time.
Adjusts sensor probe readings for temperature (-20°F to 20°F) and humidity (-10% to 10%).
Customizes ramp-up levels in AUTO mode based on temperature, determining how much trigger point must be surpassed.
Customizes ramp-up levels in AUTO mode based on humidity, determining how much trigger point must be surpassed.
Determines the level a device runs at when triggered ON, set in ON MODE. Cannot be zero.
Sets a minimum run level for devices, used in OFF MODE, until triggered ON.
Steps for powering on a device and pairing it with the AC Infinity app via Bluetooth.
To Next Page